CombatController
Member
This 646 is from the second batch S&W produced, I believe it is #98 of 300 made.
It is not the performance center model. I had it bored out to 10mm and ran some low pressure rounds through it. I fluxed the cylinder afterward and it showed zero problems. According to S&W it was proofed much higher than 37k and as .40 is at 35k the low pressure 33k psi 10mm and .40 I shot out of it would have had no effect as I proved. It is quite pleasant shooting Winchester Silver Tip 10mm (34,700 psi) out of it!
I have a spare .40 Ti cylinder I listed separately but I would be willing to bundle with this gun if desired.
I have shot this gun very little in the years I have owned it and it's very nice. I will take $950 plus shipping for it. A part of me doesn't want to let it go but I barely shoot any of my 610's at the moment.
More pics will be posed once I charge my camera battery!
It is not the performance center model. I had it bored out to 10mm and ran some low pressure rounds through it. I fluxed the cylinder afterward and it showed zero problems. According to S&W it was proofed much higher than 37k and as .40 is at 35k the low pressure 33k psi 10mm and .40 I shot out of it would have had no effect as I proved. It is quite pleasant shooting Winchester Silver Tip 10mm (34,700 psi) out of it!
I have a spare .40 Ti cylinder I listed separately but I would be willing to bundle with this gun if desired.
I have shot this gun very little in the years I have owned it and it's very nice. I will take $950 plus shipping for it. A part of me doesn't want to let it go but I barely shoot any of my 610's at the moment.
More pics will be posed once I charge my camera battery!
