386Sc/S rear sights

[dak109]

I just got an almost new 386Sc/S, new simply rugged holster and am working on new grips. Now for the problem/question. The rear sight seems to hang up the gun when draw from strong side. Can't afford/won't give up the holster or gun. Who makes a low profile rear sight? Or should I try to put a big radius in the corners of the rear sight? Has anybody done this before? Outcome?
Thanks

 

[dak109]

I just got an almost new 386Sc/S, new simply rugged holster and am working on new grips. Now for the problem/question. The rear sight seems to hang up the gun when draw from strong side. Can't afford/won't give up the holster or gun. Who makes a low profile rear sight? Or should I try to put a big radius in the corners of the rear sight? Has anybody done this before? Outcome?
Thanks

 

[pwelsh4hd]

If partial to the holster...could a local leather tooler rework the holster just a little bit for ya'?....perhaps someone like a local shoe repair shop (they are typically pretty good at working with leather and making it look nice). That would be my first choice, before I started altering the revolver.

 

[Bandersnatch]

for the moeny, you could buy a new set of sights and have the originals kept for resale value etc.

They are expensive in my opinion but the Extreme Duty Sights from C&S would seem to fit your needs.

link to Cylinder and Slide EDS.

 

[dak109]

Thanks. I am not sure what my local leather guy could do, but may check. Thanks also for the link, That is along the line I was thinking. You are right a bit pricey.