559 extractor replacement issues-Need your help

[MikeRuth]

Hi folks, I am new here and I work on my own guns when ever possible. I have a 559 that has a broken extractor. I looked up the parts on Numrich and ordered from them and the extractor I received is definetly not the correct one. My fault, theres, I don't care just need to sort this out.
I'm attching some pictures for clarity and to show what I have. I looked at every series 59 drawing that was on thier site and after receiving the parts realized something is off. My extracotr is thicker and uses a plunger where as all the drawings I saw showed an extractor with a pin through it and side pushing spring. I'm open to any suggestions, schenmatics etc and or part numbers here.

A big thanks in advance.
MIke R

 

[4T5GUY]

The good news is that Jack First has them in stock. The bad news is the price.

My early 439 has the same extractor and I’m always on the lookout for an inexpensive NOS one just in case.

Jim

 

[jsbethel]

I have always understood that S&W was going for a military contract with those extractors.

 

[BigBoss3006]

Numrichs shows the correct XM9 tool-less extractor in stock under the 459, for half of Jack First’s price. I believe the harder part to source for slides is the spring or plunger. Im sure they would swap it out if you give them an email