6 shot to 7 shot conversion

[Revolver King]

I converted this 6 shot to a 7 shot before and after.

after it doesn't show it in this picture, but I also had it moon clipped too.

 

[Bullseye Smith]

Very nice King, Moon clips makes it very nice, are you going to do the 686SSR?

 

[PinkGunsRSilly]

pretty cool. of course you could have left it stock and bought a semi auto or an 8 shot rev. if you were worried you couldn't get the job done in 6

 

[Evil One]

Personally, I think making what you want is a lot cooler than just buying something else.


Jim

 

[Bullseye Smith]

I see you also changed the thumb latch, bet you are going to use it for a pin gun .

 

[McPita]

One question on your very neat conversion job. When installing the 7 shot cylinder were you required to change to a hand specifically designed for the 7 shot cylinder or were you able to fit a normal 586/686 hand?

 

[Revolver King]

Very nice King, Moon clips makes it very nice, are you going to do the 686SSR?

I already did the SSR conversion 1st.
The only thing I had to do on this conversion was increase the cyl. to barrel gap. it was around 2 and I went to 4.

 

[colt44sp]

pretty cool. of course you could have left it stock and bought a semi auto or an 8 shot rev. if you were worried you couldn't get the job done in 6

Looks worth it just not have that 'Klinton' lock like the factory 686+ does.

BTW, nice looking piece. And what do you have to do to the action for that conversion. Timing etc.

 

[Revolver King]

And what do you have to do to the action for that conversion. Timing etc.[/QUOTE]

No action work required. It has a Clark Custom action job. It is timed very well without and changes.