Dead trigger M&P9 arg!

[Nitrous SSC]

Two trigger bars on the way. I checked all my other M&P's and they are H's as well. So I'll have a spare that will fit any of them. I didn't order the slide stop. I have gen 2 ones and the trigger reset I'm fine with.

Thanks again for the help. I also appreciate the holding back in the typical "oh your an idiot for screwing with things" blah blah flaming that often happens on forums when someone makes a mistake. I've never ever seen that on my 12 years on here.

I've just got my fingers crossed this is the issue. I'll be sure to update once the new part gets here and installed.

 

[Rastoff]

I also appreciate the holding back in the typical "oh your an idiot for screwing with things" blah blah flaming that often happens on forums when someone makes a mistake. I've never ever seen that on my 12 years on here.

I've seen it here, but very rarely. That's one of the reasons I like it here.

But just so you don't feel left out...
You're a moron for trusting that we know what we're talking about.

 

[CBStuard]

I am not understanding how having the loop too far open could cause a malfunctioning trigger. Please educate me.

 

[Nitrous SSC]

I am not understanding how having the loop too far open could cause a malfunctioning trigger. Please educate me.

I have opened and closed the loop several times and even bent it horizontally making adjustments to have it break right where I want it. When you watch Apex video's he uses feeler gauges. Mine has been opened to where you could drive a truck through it. I believe it's lost its correct geometry/curve and it's jumping off the sear. I did a more thorough bend back and went to the range just to test 25 rounds of a new receipt expecting the problem but it didn't come back. However just to be sure I'm getting a new one. Being in the middle of a match and having a dead trigger is not only horrible for your scores it's also extremely embarrassing. My carry 40c has the same apex stuff in it but I did most absolute minimal adjustments for function. My 9 for matches I screwed with a lot. Brownells e-mailed me a tracking number and they won't be here until the 11th. (Holy **** they ship slow.)

 

[CBStuard]

I have opened and closed the loop several times and even bent it horizontally making adjustments to have it break right where I want it. When you watch Apex video's he uses feeler gauges. Mine has been opened to where you could drive a truck through it. I believe it's lost its correct geometry/curve and it's jumping off the sear. I did a more thorough bend back and went to the range just to test 25 rounds of a new receipt expecting the problem but it didn't come back. However just to be sure I'm getting a new one. Being in the middle of a match and having a dead trigger is not only horrible for your scores it's also extremely embarrassing. My carry 40c has the same apex stuff in it but I did most absolute minimal adjustments for function. My 9 for matches I screwed with a lot. Brownells e-mailed me a tracking number and they won't be here until the 11th. (Holy **** they ship slow.)

Thanks. I get it now. I messed w/ mine opening to .031" and like how it feels. But you had some left/right bending too which I can see could cause problems.

 

[Nitrous SSC]

New bar is in. Along with a spare. Made as small adjustments as possible. Slammed the slide back pretty hard a quite a few times and no dead trigger. I'll run some through it at the pin shoot Thursday. Hopefully it'll be good to go.

 

[Nitrous SSC]

Hit the range this morning after dropping the kid off at school. Back to 100%!

Thanks for the info/help everyone.