Arquebus357
Member
I find this thread interesting but I have a question for Mike0251.
How did you use shims to tighten the cylinder/barrel gap from .009" to .004" ? I'm very surprised nobody else has asked this.
My impression is that the only way to do this is by putting shim/shims in the extractor star area and that is a no-no.
Am I wrong ????
How did you use shims to tighten the cylinder/barrel gap from .009" to .004" ? I'm very surprised nobody else has asked this.
My impression is that the only way to do this is by putting shim/shims in the extractor star area and that is a no-no.
Am I wrong ????
Last edited:
