Quest for "Perfect" 44 Special Load?

I did some more shooting today with the bullets from Matt's. Had some time at mid-day and lot's of light so I hiked up to my range. I was really impressed with how well they shot. The best load for my gun was 8.8 grains of Longshot, WLP primers in Winchester brass. I didn't Chronograph them, but in the past this load has produced about 975fps with a 250 SWC.
At 50 yards I had some good groups, 3-4". With a center hold in the 6" bull of a NRA 100 yard Military rifle target they all stayed in the black, then I shot a cylinder full at a 10" white paper plate at the 100 yard line. 5 of the six rounds hit the plate with a center hold, the group was about 12". This was pretty interesting as all my other loads had been about 8" low @100 when sighted in @ 50. I shot a few rounds @ 25 yards, they were about 2" above point of aim.
I have a 10" gong @ 50 yards and another 10" gong @ 100 yards. A center hold gave me center hits on the 50 yard gong while a center hold gave me hits on the bottom half of the 100 yard gong. A slightly above center hold on the 100 yard gong gave me several strings with 4 hits out of 6 shots.
This is a really good performance for me.
Matt's bullets left very little leading, appears to be more of a smear of lube than a build up of lead. Accuracy didn't seem to degrade at all over 50 rounds.
I do believe this load will do anything I'd ask of a 44 special.
I'm gonna need a lot more of Matt's bullet's!
 
Good job!!!

You will find that the loads/pressures you keep finding that are the most accurate is the "zone" in which your revolver will perforn the best. That's an excellent alloy that matt's cast those bullets with. It's an extremely easy alloy to duplicate.

Duplicate ='s ww's (clip on wheel weight lead) or most outdoor range scrap lead + 2% tin.
 
I'd like to start casting some day, got a lead pot, a few molds and an old lubri-sizer. Just need to get started.
 
Back
Top