Removing corroded batteries from a flashlight

Joined
May 10, 2018
Messages
328
Reaction score
364
Location
Colorado
Anyone have any hints on removing corroded alkaline batteries from an aluminum flashlight? I have a Streamlight Twin Task 3C that I've used as a shop flashlight for a few years. When it quit working, I went to replace the batteries, only to find they had leaked (not naming any names, but they start with a D ). The one farthest from the emitter came out OK, but the next two were stuck. I dribbled oil down the tube, and, after about a week, pounding the tail end on a hard surface every once in a while, the second battery finally dislodged, but the third has defied me.
It's not a super pricey light, but I like it, and they apparently don't make them anymore. I also hate to just throw something out if I can make it work again. I haven't figured out how to take the emitter end off, so that's off the table. Any advice would be appreciated.
 
Register to hide this ad
No help. On several occasions I have tried immersion in hot water to dissolve the corrosion. That did not work. I just got new flashlights. One of mine ruined was a three cell Mag-Lite. I am not much of a flashlight snob. Cheap plastic ones do all the lighting I need done.
 
Last edited:
Heard thru the grapevine to try armor all? Haven't had the need to since then. Before that I had some batteries go south in my 7 cell chrome flashlight that just happened to have great sentimental value. Soent a lot of time & effort to try to repair but no joy. Good luck
 
Same happened to me years ago when the aluminum mag lites became popular. The white powder from the corrision got in my eyes as I banged the case to get the batteries out....GEEZ!! what a joke
 
Rather than banging on the table, use a rubber mallet. Hold flashlight with open front end down, whack flashlight butt with rubber mallet.

Rubber mallets are really useful. Cheap, too.
 
Lanterns and flashlights I have all use
Double or Triple As with easy access,
no "long tube" models. Cheap, lightweight.
extremely bright and easy to tote. And durable.
Best part cheap. Love the Triple As models with
the removable battery modules.

Any corrosion, easy removable and a brush out.
 
Any advice would be appreciated.
The God of all penetrates, Kano Kroil
No shop is complete without it. ;)
promo-8oz-kroil-original-penetrant.jpg
 
Lash the light tube to the end of a stick. Pound the stick on a wood block, etc. surface such that the open flashlight tube end end does not contact a surface to be damaged.

Like pulling a bullet, it’s all about club head speed. Be careful. When the battery does break free it can come out with considerable force.
 
Dura-cell replaced that exact same flashlight for me a number of years ago.
Don't let 'em skate on yours.
And....... ammonia eats up battery acid corrosion quickly.
 
Sounds to me like the battery isn't just corroded. It's swollen. In that case it MAY be a lost cause. A good lubricant down the sides as much as possible, let is soak for a while, then pound the sucker out assuming it will pound. I have had to throw out one Streamlight for that reason. It got put away and forgotten and the batteries leaked and swelled up. Never could get the middle one out.
 

Latest posts

Back
Top