S&W Shield One Piece Guide Rods!

Very interested in this. My disc bent (new one on the way from S&W), so I'll be interested to see how this performs.
 
Could the problems with the factory recoil spring and guide rod have anything to do with how it is positioned where the disc contacts the barrel? The manual makes it look like only a small portion of the disc should make contact with the barrel, in effect making the guide rod assembly paralell with the slide. Is this correct or should the disc be seated as far down as possible?
 
I would just like to know how well it functions?

How well does it control felt recoil as compared to the stock dual?

How long will it last?

If it is better than the stock one, then I'm in!!
 
Yes you can buy springs (glock,etc..) and fine tune it if you want, but just the little shooting I did today ... holy hell its night and day difference. Will have a torture test video coming soon though 500rds at the range on my go pro to show performance.

Why didn't you just come out and say your promoting this product...not saying its bad...but reading between the lines your probably involved with this company in some way...hope it works out for you...good luck...
 
I am interested in this but i do not like that I have to send them my guide rod to use for the new one.
 
Back
Top