kenny brooks
Member
what do you need to convert it to a 4 inch barrel,has 2 0n it now
smith wesson model 15-3
- Thread starter kenny brooks
- Start date
Register to hide this ad
You will need a barrel, and an ejector rod for the 4 inch barrel.
I'm sending you a PM.
Bill
I'm sending you a PM.
Bill
amd6547
Member
Why not just buy a four inch Model 15? The 2" model is in demand, and four-inc Model 15s are out there for the same or less then you would pay for parts and gunsmithing...J&G sales had DA-only Model 15s pretty cheap.
Overall, a bad move to convert a 2 inch Model 15.
Overall, a bad move to convert a 2 inch Model 15.
Mike in SC
Member
2" to 4"
I did just the opposite and I changed the rear site but it was cosmetic.
I did just the opposite and I changed the rear site but it was cosmetic.
amd6547
Member
Actually...it should be a crime to change a 2" model 15 to a 4".
OP
kenny brooks
Member
sw15
just a thought now,still pondering..
just a thought now,still pondering..
SW CQB 45
Member
- Joined
- Apr 4, 2006
- Messages
- 19,854
- Reaction score
- 31,831
The cost to do what you are asking is simply "cost prohibitive". Just buy a 4" model. There are plenty around and shouldn't be hard to find. Aside from which, when you start monkeying around, they usually don't come out as good as they would if it were built that way from the get-go.
chief38
chief38
