Still have 41 problems

[MJK-MOD-547]

After you get it all cleaned up run some of this down your

barrel,swab with a patch and see what you missed.

 

[GLT721]

All suggestions and advise are appreciated. I know it is impossible to diagnosis problems over the internet. Also, I just enough about the internal working of this gun to get myself in trouble. i have decided to send the pistol tl Clark Custom Guns to get repaired.
Thanks again.

 

[Rosco Shooter]

Still Have 41 Problems

Are you absolutely sure you aren't accidentally engaging, or even touching the safety lever at all while you are shooting it? I have found on mine it is quite easy to slightly move the safety lever if you aren't careful and it results in a similar condition as yours. The hammer will fall, but the round doesn't go off. I have learned to avoid touching the safety lever at all.

Rick H.

I had a similar situation occur when I installed custom grips on my 41. The grips were cut so my thumb engaged the safety after firing a shot. This was especially irking when shooting the Timed Fire and Rapid Fire portions of Bullseye matches at my local gun club. I solved the problem by disabling the safety by placing a folded piece of paper under the safety lever and tightening the screw.