rubber ducky
Member
Hi folks!
Long story short, I've had this heavy barrel for a few years, just sitting in my box of parts that i don't use - and was recently thinking about putting it on a revolver.
About the barrel - its about 6 inches, and judging by the length of the forcing cone area, i'm assuming its for a K frame .38. My assumption is also based on the marking "K 85" stamped on the recessed area where the ejector rod would fit into (My apologies, I don't know all the technical terms or nomenclature).
My question is - despite my assumptions that this is made for a K frame revolver, would I be able to fit this on a L frame .357?
If i could, i was going to put it on something like a 681, and have a pic rail carved out of it - unfortunately, I don't have any pics of this barrel, or the Bo-Mar rib sight that was also with it, but if need be, I will try to get some pics posted - if it helps.
Many thanks in advance,
rd
Long story short, I've had this heavy barrel for a few years, just sitting in my box of parts that i don't use - and was recently thinking about putting it on a revolver.
About the barrel - its about 6 inches, and judging by the length of the forcing cone area, i'm assuming its for a K frame .38. My assumption is also based on the marking "K 85" stamped on the recessed area where the ejector rod would fit into (My apologies, I don't know all the technical terms or nomenclature).
My question is - despite my assumptions that this is made for a K frame revolver, would I be able to fit this on a L frame .357?
If i could, i was going to put it on something like a 681, and have a pic rail carved out of it - unfortunately, I don't have any pics of this barrel, or the Bo-Mar rib sight that was also with it, but if need be, I will try to get some pics posted - if it helps.
Many thanks in advance,
rd
