Must See Videos! - Disassembly etc.

[preventec47]

Probably should rename the message and make these links
to the three videos a sticky at the beginning of the Forum

YouTube - Smith & Wesson Mod 4506 advanced takedown

 

[4864]

A OK set of videos, but he did miss showing a few steps on the frame reassemble. He did them but didn't show them. I disagree with him telling people not to use a hammer on guns. A plastic or rubber mallet is just fine for gun work. Him using the metal end of the punch to put the trigger pin back in is not a good idea. You can damage the head of the pin doing that. Also some grips pins are a pain to get out and back in if you put different grips on. A gunsmiths mallet is a must some times.