Need all kinds of suggestions

I use Hodgdon TITEGROUP exclusively for 9mm and .40 S&W. I like Titegroup because it is not case sensitive and is a very clean burning powder. Another advantage is that my favorite load is 4.4 grains for both 115 grain 9mm and 180 grain .40 S&W, so I don't have to change the powder drop adjustment on my Dillon 550B when I change tool heads.
 
You've been given lots of good advice and sounds like you are fortunate enough to have most of what you need. Unfortunately this is a poor time to be looking for anything you don't already have. Supplies are limited and the prices are high. I wish you the best of luck with it and welcome back to the fold. :D
 
you may do this already but when working up a load make only a mag or 2 no more to test function and accuracy. I had in early days of my dillion look up a load then make a few hundred to find they did not function my autos learned my leason
 
It's too bad we don't live near each other. I could lend you some primers and powder but shipping them is out of the question!

I have lent some primers and powder to two shooting buddies when they ran out.
 
Just a little note on all those burn rate charts that are out there.

Please read then with a grain of salt..........
since they are all different and can be 2-3 powders off from another companies listing.

I don't agree with the fastest powders on many of the charts and with
my test loads over the years I have my ideas of where many powders fit in the burn rate sections but they may vary from your test.......

so please use as a guide and not a 100% solid fact.
 
Back
Top