nimbly
Member
I am half thinking about putting different sights on my pistol. There are some Williams Firesights on Epay for 40 bucks. Anyone have any experience with these?
SD9VE Sight Options
- Thread starter nimbly
- Start date
Register to hide this ad
sgtsandman
US Veteran
Not on the SD9 but I've had a limited experience with them. On my 10/22, they shot high. On the PT145, they were better than the stock Hine 8 sights. I do like the better visibility they offer over a stock sight.
Disabled1
US Veteran
Remember this, any M&P sights will fit on your SDVE series gun. There are A LOT of M&P sights for sale out there!
djt17
Member
I went with HiViz Red Litewave front sight (said it was for an M&P); made a world of difference.
Steelhat
Member
Are there differences in height with different calibers?
I know that SIG got different heights for the .40S&W and .45ACP than for 9mm and .357SIG. So do I have to get sights for a M&P 9mm for the SD9VE and sights for M&P .40 for the SD40VE??
I know that SIG got different heights for the .40S&W and .45ACP than for 9mm and .357SIG. So do I have to get sights for a M&P 9mm for the SD9VE and sights for M&P .40 for the SD40VE??
ajwalk2008
Member
- Joined
- Jun 5, 2017
- Messages
- 12
- Reaction score
- 4
Do they all have to be pressed onto the dove tail on the slide? Or do they have some that have a set screw to tighten to the slide?
Sent from my iPhone using Tapatalk
BlackTalonJHP
Member
The front and rear are both dovetailed and you will need a punch or sight pusher The rear has a set screw but is tight enough to not need it. In my experience some of the aftermarket front sights are a little too small and I've always used loctite on them or else I could move them with finger pressure.
Disabled1
US Veteran
I have heard a few people state this before. But, with all of the SW/SD/SDVE front sights I have installed I have YET to have this problem.
IMO, besides the wider take down lever, adding M&P sights to this handgun is the BEST investment/add on there is.
Similar threads
